|
|
 |
|
|
 |
 |
 |
* Make sure your project and work area is dust free.
* Use and store 3-D Crystal Lacquer at room temperature.
* DO NOT SHAKE 3-D Crystal Lacquer. It will create air bubbles.
* Have extra tissue and cotton swabs handy for corrections.
* Paint brush (optional) can be used for background.
* Normal drying time is 15 to 30 minutes. Larger areas and thicker application will take longer to dry.
* When dried completely, it will appear “Crystal Clear”
* After you finish the project, make sure to wash the applicator tip with running warm water throughly |
|
 |
|
1). Remove the cap from the bottle and install the spout. (Fig. 1)
2). Dispose the original cap.
3). Remove the long cap from the top of the spout.(Fig.2)
4). Cut off the spout using scissors or knife as
indicated on Fig.3.
5). Twist and push applicator tip onto
the spout you just cut.(Fig.4) |
|
 |
|
6) After you use 3D crystal lacquer, remove the applicator tip and wash with running warm water. Store the tip in a safe place. Replace the long cap back onto the spout to keep lacquer from drying up. |
|
 |
|
1) While you are using 3D crystal lacquer, let it sit (tip side down) on a moist paper towel in a container. This will prevent the tip from becoming dried & clogged while in used. (Fig.5)
2) When you are finished, wash the tip with running warm water making sure the inside is clean. You can blow into the tip to clear all water from inside the metal tube. |
|
 |
|
|
|
|
